Concentrated Machine Plaster

Product Information

It is a bagged, gypsum-based concentrated machine plaster.
It is applied directly on materials such as brick, concrete, exposed concrete, aerated concrete, and pumice blocks.
Thanks to its special formula, the amount of gypsum used per square meter is reduced.
When used in the same amount as standard machine plaster, it covers 25% more area.
When loaded in the same weight as standard machine plaster, 25% more bags are transported, resulting in transportation savings.
In a single coat, it prepares the surface for painting without the need for a satin finish plaster.
It has high surface hardness and a glossy appearance.
It is a non-combustible material. Due to the water in its composition, it has fire-retardant properties.

Since it is a breathable material, it balances humidity and creates a healthy environment.

Operating Time	Net Weight	Application Temperature	Consumption	Referance Standard

Application Surface Features

On Brick or Pumice Block Surfaces:
Brick surfaces should be wetted before application in hot weather, but there is no need to wet pumice block surfaces before application. The minimum application thickness should be 10 mm. A maximum of 30 mm can be applied in a single coat.
On Exposed Concrete Surfaces:
Exposed concrete surfaces should be roughened with AkAlçı Adhesion Enhancer Primer at least 12 hours before application. The minimum application thickness should be 8 mm. A maximum of 30 mm can be applied in a single coat.
On Aerated Concrete Surfaces:
Aerated concrete surfaces should be cleaned of their dust before application and slightly wetted in hot weather. The minimum application thickness should be 8 mm. A maximum of 30 mm can be applied in a single coat.

Instructions for Use

The water setting of the plaster machine should be adjusted to use approximately 6.5 liters of water for every 10 kg of AkAlçı Concentrated Machine Plaster, and the plaster is poured into the machine hopper to start the application.
Before starting the application, the surface should be cleaned of dust and substances that prevent adhesion.
Ano guides are adhered to the surface at intervals of 150-200 cm.
The application is done in two stages with a steel spatula.
The AKALÇI CONCENTRATE MACHINE product is mixed with the plaster machine and sprayed between the ano guides.
After spraying, the surfaces are smoothed using a screed.
About 15-20 minutes after the first screed, a second screed is applied.
Approximately 50-70 minutes after starting the application, water is sprayed onto the surface, and the surface is troweled with a rubber float.
About 10 minutes later, the surface is polished with a steel trowel.
The second trowel is applied about 60 minutes after the first, resulting in a shiny, hard, and glazed surface.
It should be noted that wind can significantly affect these times, shortening the intervals accordingly.